更新主板托盘上的中板 CPLD

1. 创建一个 updparameters.json 文件，其中包含以下内容

   {
       "Targets" :["/redfish/v1/UpdateService/FirmwareInventory/CPLDMID_0"]
   }
   

2. 更新固件

   nvfwupd -t ip=<bmc-ip-address> user=admin password=admin update_fw \
     -p nvfw_DGX_250212.1.1.fwpkg -y -s updparameters.json
   

   示例输出

   FW recipe: ['nvfw_DGX_250212.1.1.fwpkg']
   {"@odata.type": "#UpdateService.v1_6_0.UpdateService", "Messages": [{"@odata.type": "#Message.v1_0_8.Message", "Message": "A new task /redfish/v1/TaskService/Tasks/5 was created.", "MessageArgs": ["/redfish/v1/TaskService/Tasks/5"], "MessageId": "Task.1.0.New", "Resolution": "None", "Severity": "OK"}, {"@odata.type": "#Message.v1_0_8.Message", "Message": "The action UpdateService.MultipartPush was submitted to do firmware update.", "MessageArgs": ["UpdateService.MultipartPush"], "MessageId": "UpdateService.1.0.StartFirmwareUpdate", "Resolution": "None", "Severity": "OK"}]}
    FW update started, Task Id: 5
   Wait for Firmware Update to Start...
   Wait for Firmware Update to Start...
     TaskState: Completed
    PercentComplete: 100
    TaskStatus: OK
   Firmware update successful!
    Overall Time Taken: 0:00:09
   Refer to 'DGX B200 Firmware Update Document' on activation steps for new firmware to take effect.